Stamping Technology

Stamping Technology
  • “Stamping”
  • “Processing”
  • We have been developed our world-class level craftsmanship technology being strict to “Stamping” thoroughly. We can divide hair-thickness into 2 parts.

    Stamping Finely Stamping Finely

    Stamping Finely

    The world finest stamping is possible using our in-house metal molds. Our technology level which can divide hair-thickness into two parts is the result of our thorough pursuit of “Stamping” which is the most basic technology of NICHIDEN SEIMITSU KOGYO.

    Stamping Sharply Stamping Sharply

    Stamping Sharply

    We can make edged tools only with stamping.
    Our products are used as inner blades for electric shavers, surgical knives.

    Stamping Thick Materials

    Stamping Thick Materials

    We are also working on comparatively thick(up to about 3mm) materials pursuing heat dissipation. They are used as general heat-sink and a part of semiconductor power devices.

    Stamping Thin Materials

    Stamping Thin Materials

    We can stamp thin metal materials with less than paper-thickness precisely, rapidly, and finely We have an adoption result of the thickness 0.03mm for the parts used in motors.

    Stamping Non-Metal Materials

    Stamping Non-Metal Materials

    We can also stamp non-metal materials. Lead-fixing tape for semiconductors, resin circuit boards which you must be able to process with router, but we switched to stamping, etc.
    We are challenging various materials with our “Stamping finely technology”

  • Over 30-year experience of micron-order ultraprecise bending processing and combination of rubber and metal.

    Bending Processing

    Bending Processing

    We can offer ultraprecise bending processing with micron-order accuracy. At the same time, we can propose bending processing considering piling up the products. This is used in bending processing of islands of the chips for various semiconductor parts.

    Semi-Stamping Processing

    Semi-Stamping Processing

    We can offer continuous reproduction of precise condition of semi-stamping(stamping to half thickness of the material). This helps to secure the product shape different from bending.

    Crushing Processing

    Crushing Processing

    A partial crushing aimed at resin adhesion.
    We can offer processing with high-accuracy Stamping molds such as coining aimed at securing planation surface.

    Raising Processing

    Raising Processing

    We are manufacturing raised products mainly used for body parts such as accerelometers, gas-sensors etc.
    Mainly we manufacture fine products.

    Complex Processing

    Complex Processing

    We can offer products combined with different materials such as metal & metal, metal & resin
    We have been manufacturing “bandage stoppers” with rubber & metal parts.

    Roughening

    Roughening

    We can meet requests to roughen a certain part of products. We can propose various methods such as transcription of parts installed to molds, laser processing etc. This is adopted to some parts of small semiconductor parts which require the increase of resin adhesion and surface area.